Transporting And Storing The Fastener Driving Tool; Packing - Prebena 3X-CNW50 Manual De Instrucciones Original

Transporting and storing the fastener driving tool

Transporting and storing the fastener
driving tool

Packing

Pack the fastener driving tool before placing it in storage or transporting
it over the following distances:

Distances longer than 10 m

Distances that lead over an uncertain subsurface

Distances that must be covered in an unusual body position.
To do this carry out the following preparatory steps:

Disconnect the fastener driving tool from the compressed air supply.

Allow the pressure to be completely released from the fastener
driving tool.

Empty the magazine.

If necessary clean extraneous objects and impurities out of the
compressed air connections.

Place the fastener driving tool in the transport case.

Close the transport case and the bar for the cover.
Transporting
The type of transport determines whether you are transporting
the fastener driving tool over short or long distances.
Transport over short distances
Short distances are no longer than 10 meters in length.

Disconnect the fastener driving tool from the compressed air supply
every time when transporting it.

Carry the fastener driving tool only by the handle.

Do not touch the trigger during transport.

Disconnect the fastener driving tool from the compressed air supply.
34
WARNING
Accidental triggering may result in
severe or fatal injuries.