Delta 31-695 Manual De Instrucciones página 12

LOCKING SWITCH IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the
switch should be locked in the "OFF" position to
prevent unauthorized use. To lock the machine, grasp
the switch toggle (A) and pull it out of the switch (Fig. 17).
With the switch toggle (A) removed, the switch will not
operate. However, should the switch toggle be removed
while the sander is running, the machine can be turned
"OFF," but cannot be restarted without re-inserting the
switch toggle (A).
In the event of a power outage (such
as a breaker or fuse trip), always move the switch to
the "OFF" position until the main power is restored.
TRACKING THE SANDING BELT
Disconnect machine from power source.
NOTE: Remove the guard (G) Fig. 18 before making
the following adjustments. Simply pull the guard
off the mounting studs.
1. Turn the switch "ON" and "OFF" to see if the sanding
belt tracks correctly. If the belt does not move to
one side or the other and rides on the center of the
sanding drums, the belt is tracking properly.
2. If the sanding belt moves toward the disc, turn the
tracking knob (B) Fig. 18 clockwise 1/4 turn. (See
arrow, Fig. 18)
3. If the sanding belt moves away from the disc, turn the
tracking knob (B) Fig. 18 counterclockwise 1/4 turn.
4. Turn the switch "ON" and "OFF" again to check the
tracking. Adjust again, if necessary.
5. Replace the guard (G) Fig. 18.
CHANGING THE POSITION OF THE SANDING ARM
The sanding arm (A) Fig. 19 can be used in the horizontal position (Fig. 19), or in the vertical position (Fig. 20), or any
angle in between. To change the position, loosen the screw (B) Fig. 20 with the hex wrench (C), move the arm (A) Fig. 20,
to the desired location and tighten the screw (B).
D
C
Fig. 19
All manuals and user guides at all-guides.com
B
A
12 - English
B
Fig. 20
A
Fig. 17
G
Fig. 18
A
C