Replacing The Sanding Belt - Delta 31-695 Manual De Instrucciones

ADJUSTING THE DUST SHIELD
This sander is equipped with a manually operated dust shield (A) Fig. 33 for use with a dust collection system. You must
adjust the shield to suit your sanding operation.
1. If you are sanding with the disc, push in on the dust shield (A) Fig. 33.
2. If you are sanding with the belt, pull the dust shield (A) Fig. 34 outward.
A
WRENCH STORAGE
A hole is provided in the stand for storing the hex wrench (A) Fig. 35, supplied with the sander
REMOVING THE UPPER SANDING DRUM GUARD
You can remove the upper sanding drum guard (A) Fig. 36 to sand inside curved work or to change the belt. To remove:
1. Pull outward on the guard (A).
2. After the sanding operation is completed or the belt is changed, replace the guard (A) Fig. 36 on the two studs (B),
one of which is shown.
A
Fig. 35

REPLACING THE SANDING BELT

Disconnect machine from power source.
1. Remove the upper sanding drum guard (A) Fig. 36. Loosen the two screws (A) Fig. 37 and remove the backstop (B).
2. Loosen the two screws (C) Fig. 37, and remove support bracket (D). Fig. 38 illustrates backstop and support
bracket removed from the machine.
A
D
All manuals and user guides at all-guides.com
Fig. 33
B
C
Fig. 37
16 - English
A
.
A
Fig. 38
Fig. 34
B
Fig. 36