Assembling The Stand; Important - Delta 31-695 Manual De Instrucciones

ASSEMBLING THE STAND

IMPORTANT: Any letter designations that are stamped on
the braces of the stand are for production purposes ONLY
and are not used for assembling the stand. Follow the
instructions in this manual.
Assembling this stand (Fig. 4) requires, in each instance,
placing an M8x20mm carriage head bolt through a hole
in the front of the leg, then through the corresponding
hole in the brace. Place a 3/8" flat washer on the other
end of the bolt, and loosely secure that connection with
an M8 hex nut.
Attach the lower braces (B) and (D) (from Fig. 2) first.
When you attach the upper braces, place the short upper
braces (A) Fig. 4 on top of the long upper braces (C).
Attach a plastic foot (F) Fig. 4 on the bottom of each leg.
NOTE: Each rubber foot is provided with holes for
mounting the stand to the floor surface if desired.
ATTACHING THE MACHINE TO THE STAND
Carefully set the sander on the stand. Align the four holes on
the top of stand (A) Fig. 5 with the four mounting holes on the
base of sander (B), two of which are under (C).
Place a 3/8" flat washer on an M8 x 45mm hex head screw
and insert this assembly through the holes (two of which are
shown at C) in the base of the machine (B) and stand (A).
Place a 3/8" flat washer on the other end of the screw and
thread an M8 hex nut on the screw. Tighten securely. Repeat
this process for the remaining holes.
ADJUSTING THE DRIVE BELT TENSION
Use the supplied hex wrench (A) Fig. 6 to loosen the screw (B). Move the sanding arm (C) to the vertical position. Tighten
the screw (B).
NOTE: The drive belt (D) Fig. 7 should be firm, but not too tight on the pulleys (E and F) and should have approximately
1/4" to 1/2" deflection in the belt at the center (between E and F) when using light finger pressure. The drive belt does not
require excessive tension to function properly.
To adjust the belt tension, loosen the locknut (G) Fig. 7. Use the wrench (A) to tighten or loosen the adjustment screw
(H). When the adjustment is correct, tighten the locknut (G). After the drive belt (D) Fig. 7 has proper tension, move the
sanding arm to the horizontal position.
C
B
Fig. 6
All manuals and user guides at all-guides.com
A
9 - English
C
D
F
B
A
G
E
D
F
A
B
Fig. 4
C
Fig. 5
A
H
Fig. 7