Delta 31-695 Manual De Instrucciones página 13

ADJUSTING THE SANDING ARM STOP
A positive stop is provided to position the sanding arm level with the workbench when the arm is in the horizontal
position.
Disconnect machine from power source.
1. Place the sand ing arm in the horizontal position.
2. Place a level (A) Fig. 21, on the sanding belt.
3. To adjust, loosen the lock nut (B) Fig. 21, and turn the
sanding arm stop (C) in or out until the sanding arm is
level. After adjustment, tighten the lock nut (B).
ADJUSTING THE BACKSTOP SQUARE WITH THE SANDING BELT
Disconnect machine from power source.
1. Before making this adjustment, check to see that the belt tension lever (A) Fig. 22 is all the way to the left in the
"tighten" position.
2. Place a square (B) Fig. 23 on the sanding belt with the end of the square against the backstop.
3. If the backstop is not square with the sanding belt, loosen the two screws (C) Fig. 23, and adjust the backstop. After
adjusting, tighten the screws (C).
A
TILTING THE TABLE
Disconnect machine from power source.
You can tilt the table 45 degrees by loosening the table
lock knob (A) Fig. 24. Tighten the table lock knob after
tilting the table. A scale (H) is provided with a pointer
(G) to help you accurately tilt the table to the desired
angle.
After tilting, the table assembly must be
repositioned on the support rod (B) Fig. 24 to provide a
maximum of 1/16" distance between the sanding disc
(C), and the edge (D) of the table, to avoid trapping the
workpiece or fingers between the disc and table. To
reposition the table assembly, loosen two screws (E)
and/or screw (F), move table assembly on rod (B), and
tighten screws (E) and/or (F).
All manuals and user guides at all-guides.com
Fig. 22
13 - English
A
C
C
B
Fig. 24
D
H
B
F
B
Fig. 21
Fig. 23
C
G
A
E