Delta 31-695 Manual De Instrucciones página 14

SQUARING THE TABLE WITH THE SANDING DISC
Disconnect machine from power source.
1. Place one end of a combination square (C) Fig. 25 on
the table with the other end against the sanding disc.
2. If the table surface is not 90 degrees to the disc,
loosen the table lock knob (A) Fig. 25, adjust the
table, and tighten lock knob (A).
3. Adjust the pointer (B) Fig. 25 to the "0" degree mark
on the angle scale.
ADJUSTING THE MITER GAUGE SLOT PARALLEL WITH THE SANDING DISC
Disconnect machine from power source.
1. Place a combination square with the 90 degree angle
side (A) in the miter gauge slot and the other end (B)
against the sanding disc. Check the distance from the
slot to each end of the sanding disc (Figs. 26 and 27).
This distance should be the same.
2. To adjust, loosen the three screws (B) Fig. 28, adjust
the table, and tighten three screws (B).
Fig. 27
ACCESSORY MITER GAUGE
An accessory miter gauge is available. The miter gauge
body (A) Fig. 29 can be turned the right or left for angle or
miter sanding. To change the angle, loosen the lock knob
(B), rotate the miter gauge body, and tighten the lock
knob (B).
All manuals and user guides at all-guides.com
B
14 - English
B
A
Fig. 26
B
A
C
Fig. 25
B
A
Fig. 28
Fig. 29