Delta 31-695 Manual De Instrucciones página 15

USING THE TABLE ASSEMBLY WITH THE SANDING BELT
Use the table assembly with the sanding
belt in the vertical position ONLY.
To move the table assembly (B) Fig. 30 to the sanding
arm (A):
1. Remove the backstop (C) Fig. 30.
2. Loosen the screw (E) Fig. 30 and carefully remove
sup port bar (D) and table assembly (B) from the disc
unit.
3. Loosen the set screw (F) Fig. 31. Insert the support
bar (E) (with the table assembly (B) attached) in the
hole (G) Figs. 30 & 31. Tighten the set screw (F).
The table edge must be positioned a
maximum of 1/16" away from the sanding belt to
avoid trapping the workpiece or fingers between the
table and the sanding belt.
DUST SPOUT
A dust spout (A) Fig. 32 is supplied with your sander and
can easily be connected to a standard shop vacuum
hose. The inside diameter opening of the dust spout (A)
is 2-1/4".
All manuals and user guides at all-guides.com
15 - English
A
C
G
E
Fig. 31
F
G
A
Fig. 30
D
B
E
Fig. 32
B