Cata AG6-A600 GBK Instrucciones Para La Instalación, El Uso, El Mantenimiento página 19

2. The cooker hood should be placed at a distance of 65~75cm above the cooking
surface for best effect.
3. Using a drill bit with an 8 mm diameter, make 8 holes in the wall at the position that
you reserve for installing the chimney and cooker hood body. See Pic 2.
4. Insert wall plugs into the holes that you have drilled for the cooker hood body,
fasten 2 pcs support screw ST4*40 mm halfway in, leaving them 2 mm out of the
wall. See Pic2.
5. Hang the cooker hood onto the support screws.See pic 3.
6. Insert self-tap screw ST4*30 mm into the safety holes and fully fasten it to ensure
the cooker hood is well fixed. Note: The two safety vents are positioned on the
back housing, with a diameter of 6mm. See pic 3.
7. Attach the expansion pipe on the outlet as shown in pic 3. Fix the expansion pipe
on the outlet with a cable tie. Lift up expansion pipe till it out of the wall through the
hole on the wall. Please note the expansion pipe is not supplied.
8. Install the inside chimney bracket :Use ST4*40 screws to install the inside chimney
bracket onto the wall.See Pic 4.
19