Barrette 34111492 Manual Del Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Once posts are set, place 2" spacer blocks to
support bottom rail (Fig. 10).
7.
Place bottom rail inside the posts, resting it on
the 2" spacer blocks (Fig. 11).
TIP:
The rail may need to be inserted at an angle in
one post to start before resting it fully on the
blocks and in both posts.
8.
Pre-drill rail using a
using two
Head Driver. Bottom screw should be
the bottom of the bottom rail. Screws should be 2"
apart from each other. (Fig. 12).
9.
Back out the top screw so that the channel is
clear until infill boards are installed (Fig. 13).
Repeat Steps 7 & 8 on other post.
10.
Snap post adaptor strips into post channel (Fig. 14).
10
" drill bit. Attach bottom rail
1
8
" Hex Head screws with 5/16" Hex
3
4
" from
3
4
2"
2"
"
3
4
Adaptor Strips
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14

Publicidad

Tabla de contenido
loading

Tabla de contenido