Barrette 34111492 Manual Del Usuario página 11

11.
Install horizontal infill boards as shown. Boards
should fit inside adaptor strip (Fig. 15).
NOTE:
Lightly use rubber mallet to fully nest vinyl
boards on top of each other.
For 42" rail installations use 6 boards.
For 36" rail installations use 5 boards.
12.
Once horizontal infill boards are installed, lift the
top rail
depending on installation and code requirements.
Infill board will still sit inside the top rail channel and
provide desired privacy and required security
(Fig. 16).
Install top rail using two
Screws should be 2" apart from each other with
bottom screw attached about
bottom of the rail (Fig. 17).
13.
Remove the 2" spacer blocks from under the
bottom rail.
14.
Each post comes with sixteen (16) screws, but
not all screws are used in each assembly. For
additional security, use remaining screws to
fasten infill boards to posts. Screws should be
distributed evenly between top and bottom rail
and used on each end of the boards. Locate
screws midway between top rail and bottom rail
for best results. These screws will go into the
channel aligned with screws used to lock rails
into place (Fig. 18).
15.
Snap/slide post cover (from post kit) into place by holding cover approximately 6" from
top of post. Hook one side of the cover and push down to snap the other side. Slide
the cover down the post to hide the screws (Fig. 19). Install post cap to top of post.
Use a soft rubber mallet if necessary to obtain a firm fit. (Fig. 19)
End Cap
⁄ " to ensure that the top rail is at 42" or 36"
3
8
⁄ " Hex Head screws.
3
4
Cover
Strip
⁄ " above the
3
4
Line Cap
Line Cover
2"
3/4"
Distribute screws
evenly (minimum 1
per center)
Corner Cap
Cover Cover
Strip Strip
Fig. 15
Fig. 16
Fig. 17
Fig. 18
Fig. 19
11