Barrette 34111492 Manual Del Usuario página 7

15.
Each post comes with sixteen (16) screws,
but not all screws are used in each assembly.
For additional security, use remaining screws
to fasten infill boards to posts. Screws should
be distributed evenly between top and bottom
sections of the rail and used on each end of the
boards. Locate screws midway between all three
rails (halfway between mid and top rail, halfway
between mid and bottom rail) for best results.
These screws will go into the channel aligned
with screws used to lock rails into place (Fig 20).
16.
Snap/slide aluminum screw cover strip (from post
kit) into place by holding cover approximately 6"
from top of post.
Hook one side of the cover and push down to
snap the other side.
Slide the cover down the post to hide the screws
(Fig. 21).
Install post cap to top of post. Use a soft rubber
mallet if necessary to obtain a firm fit. (Fig. 21)
17.
Assemble post base trim over plate. Take one
side of trim ring and push plastic plugs through
hole underneath. Take second half of the trim ring
and push together (Fig. 22). Slide over plate for a
finished look.
Distribute screws
evenly (minimum 1
per center)
End Cap
Line Cap
Line Cover
Corner Cap
Cover
Strip
Fig. 20
Fig. 21
Screw
Cover
Strip
Fig. 22
7