Waeco MagicWatch MWE150 Instrucciones De Montaje Y De Uso página 27

MWE-150-2.book Seite 27 Freitag, 3. Februar 2006 4:52 16
All manuals and user guides at all-guides.com
MagicWatch MWE150
Observe the following instructions during installation:
Secure the parts of the MagicWatch system installed in the vehicle in such
a way that they cannot become loose under any circumstances (sudden
braking, accidents) and cause injuries to the occupants of the vehicle.
To prevent damage, when drilling ensure that there is sufficient room for
the drill head to emerge once the hole has been made (2, page 4).
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(1 5, page 3) or a voltmeter (1 6, page 3).
Test lamps with an illuminant (1 9, page 3) take up voltages which are
too high and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (3, page 4).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insula-
ting tape, for example to existing cables.
Please observe the following instructions in particular:
Observe the applicable legal regulations.
The sensors may not cover signal lamps.
When reversing, make sure no other road users can be injured.
Physical reflection properties mean you may not be able to recognise cri-
tical obstacles.
MagicWatch is designed merely as an additional aid, which means it does
not release you of the duty of taking due care when reversing.
MagicWatch can only provide a warning in time if you reverse slowly (at
parking speed).
Remove any snow, ice or dirt from the sensors so that the function is not
impaired.
Safety and installation instructions
27