Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
A
WARNING:
Do
not allow familiarity with products to make you care-
less. Remember that a careless fraction
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI
ZB7 .1.
objects being thrown into your eyes resulting in possible
serious injury.
A
WARNING:
Do
not use any attachments or accessories not recom
mended by the manufacturer
attachments or accessori es not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
•
Pruning branches on trees and shrubs
This product will accept Ryobi One+
packs and Ryobi One+
18 V
For complete charging instructions,
Manual and safety rules for the battery packs and chargers
for your models.
BATTERY PROTECTION FEATURES
Ryobi lithium-ion batteries
protect the lithium-ion cells and maximize battery life.
If the tool stops during use, release the trigger to
resume operation. If the tool still does not wori<, the batte ry
needs to be recharged.
A
WARNING:
Always remove battery pack from your tool when you
are
assembling parts, making adjustments, transporting,
cleaning, or when not in use. Removing battery pack
will prevent accidental starting that could cause serious
personal injury.
All manuals and user guides at all-guides.com
OPERATION
of
a second is
Failure to do so could result in
of
this product. The use of
18 V
lithium-ion batt e ry
nickel-cadmium batte ry packs.
refer
to the Operator's
are
designed with features that
reset
TO INSTALUREMOVE BATT E RY PACK
See Figure 2.
To install:
•
Insert the battery pack into the product
Make sure the latches on each side
•
snap into place and the batt e ry pack is secured before
beginning operation.
To
remove:
•
Depress the latches on each side of the battery pack.
•
Remove the batte ry pack from the tool.
A
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
TO INSTALUREMOVE BLADE
See Figure
3.
•
Remove the batt e ry pack from the pruner.
•
Rotate the blade clamp counterclockwise before installing
or removing blade and hold to open.
•
Insert blade until it is fully seated.
•
Release the blade clamp to secure.
remove
•
To
the blade, rotate the blade clamp counter-
clockwise and hold.
LOCK-OUT BUTTON
See Figure 4.
The pruner is equipped with a lock-out button which reduces
of
the possibility
accidental starting. The lock-out button is
located on the handle above the switch trigger. You must
and
depress the lock-out button in order to pull the switch
trigger. The lock-out button
can
released. You
the left or right side.
8-
English
as
of
the battery pack
resets
each time the trigger is
depress the lock-out button from either
shown.
Publicidad
Tabla de contenido
