Product Set Up - Nuna tavo Manual De Instrucciones

Product Set Up

Open Pushchair
1
- Open the storage latch as shown. (1)
2
- Rotate the handle to the rear of the pushchair. A "click"
sound means the pushchair frame is open completely.
Check that the pushchair is completely latched open
before continuing. (2)
Front Wheels
1
- Insert the front wheel into the front leg. A "click" sound
means the wheel is assembled completely. (3)
Check the wheel is securely attached by pulling out.
Repeat on opposite side.
2
- To remove the front wheel, slide the release button out
(4)-1 and then detach the front wheel from the front leg
(4)-2.
Brake Assembly
Make sure the brake lever is up before attaching the brake
assembly to the frame.
1
- Push the brake assembly onto the rear leg tubes. A
"click" sound means the brake assembly is attached. (5)
Check that brake assembly is securely attached by
pulling on it.
11 TAVO instructions
All manuals and user guides at all-guides.com
Rear Wheels
1
- Insert the rear wheel into the rear leg. A "click" sound
means the rear wheel is assembled completely. Repeat
on opposite side. (6)
Check that the wheels are securely attached by pulling
on them.
2
- To remove the rear wheel, press the release button (7)-1
and detach the rear wheel from the rear leg (7)-2.
Storage Basket
1
- Wrap the basket flap around the rear frame and
fasten the 3 snaps. (8)
Arm Bar
Always secure the child with the harness. The arm bar is
not a restraint device.
1
- Align the arm bar ends with the arm bar mounts, and
insert until it clicks into place. A "click" sound means the
arm bar is assembled completely. (9)
2-
To remove the arm bar, press the arm bar release buttons
(10)-1, and lift the arm bar up. (10)-2
Check Set Up
Pushchair frame is latched open
Rear and front wheels securely attached
Canopy mount attached to pushchair frame and canopy
zipped to seat pad
Basket securely attached
Arm bar securely attached
TAVO instructions 12