Setting The Slave Group; Testing Remote Flash Mode - Metz mecablitz 52 AF-1 Canon digital Manual De Instrucciones

10.2.3 Setting the slave group

REMOTE CH
A
SLAVE 2
• Press the sensor button on the touch
display for the channel group (e.g
Z
35 mm .
OOM
The window for selecting the channel and
EV
INFO group appears.
CH
2
• Press the sensor button on the touch
display for the group "GROUP".
GROUP
A
GROUP
• Press the sensor button on the touch
A
display for the desired group "A", "B" or
B
"C".
C
The setting will take effect immediately.
A I CH2
)

10.3 Testing remote flash mode

• Place the slave flash units in the desired
positions for the shot. Use flash unit moun-
ting foot S60 (optional accessories, see 18)
to set up the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF measuring
beam will blink.
• Press the manual firing button on the
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the sla-
ve flash unit so that it is able to receive
light from the master flash unit via the sen-
sor .
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.
k
173