Servo Mode Partial Light Output Settings; Learn Function - Metz mecablitz 52 AF-1 Canon digital Manual De Instrucciones

10.4.3 Servo mode partial light output
SYNC
settings
M-SERVO
• Press the sensor button
Z
35 mm output on the touch display as many times
OOM
as it takes for the partial light output
INFO P display to appear.
• Press sensor buttons
1/1
touch display and set the desired partial
-1 light output to 1/1, 1/2, 1/8 or 1/128.
1/1 /
3
-2
1/8 /
• Press the sensor button on the touch
3
display for the selected partial light output
1/16
1/16
(e.g.
-1
1/16 /
3
The partial light output is adopted.
Once the slave flash units have achieved
SYNC
M-SERVO
flash-readiness, the AF measurement flash
flashes.
Z
35 mm
OOM
Slave groups and remote channels cannot be
set in SERVO mode.
INFO 1/16
The camera flash unit may not work in the
remote mode.
P
for partial light
on the
(z.B. 1/16).

10.4.4 Learn function

The "Learn function" enables individual auto-
matic adjustment of the slave flash unit to
the flash technology of the camera's flash
unit.
In the process, one or more pre-flashes, e.g.
to reduce the "red-eye effect" of the camera
flash unit can be taken into account.
The slave flash unit is then fired to coincide
with the main flash that illuminates the
actual picture.
+
If the camera's own flash device provides for
automatic focussing AF measuring flashes,
then due to the system characteristics no
learn operation is possible. If possible, use
another camera mode or change to manual
focussing.
k
175