Blade Maintenance - Bosch Isio Manual Original

All manuals and user guides at all-guides.com
OBJ_DOKU-31309-001.fm Page 43 Thursday, July 5, 2012 3:50 PM
If the garden product should happen to fail despite the care taken in man-
ufacture and testing, repair should be carried out by an authorised cus-
tomer service agent for Bosch garden products.
In all correspondence and spare parts orders, please always include the
10-digit article number given on the type plate of the garden product.

Blade Maintenance

Always clean the cutting blades after operation and lubricate with Bosch
Maintenance spray. During longer cutting jobs, we recommend periodi-
cally lubricating the cutting blade with Bosch Maintenance spray.
Visually check the condition of the cutting edges of the cutting blade.
Ensure that the cutting blade is covered with the blade guard supplied
when not in use.
Changing the Blade (see figures E
Warning! Switch off before adjusting or cleaning. The blades con-
tinue to move for a few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
Always wear protective gloves when using, adjusting or cleaning
the garden product.
Do not do the blade change without blade covers.
Blade Removal (see figures E–G)
Push the SDS drive cover release button 11 and slide the SDS
E F
drive cover 6 towards the On/Off switch 5. Lift away from the housing.
Lift the blade 1 out.
G
Blade Fitting (see figures H J)
–
Fit the blade 1 as shown aligning the holes in the blade onto the drive
H
pins and locate the blade 1 under the retaining rib in the rear corner of the
housing.
When refitting the SDS drive cover 6 ensure all 4 location legs are in-
I
side the housing prior to sliding cover into place.
Bosch Power Tools
English | 43
J)
–
F 016 L70 473 | (5.7.12)