ROBBE AIR TRAINER 140 ARF Manual De Construcción Y De Uso página 8

Programming the speed controller using the transmitter (four steps):
Note: Please ensure that the throttle stick is at the Idle position (fully back), and that throttle travel is set to 100%.
1. Start programming mode
1) Switch transmitter on, move throttle stick to full-throttle,
connect battery to speed controller.
2) Wait two seconds: you should hear a "beep- beep-"
sound.
3) Wait a further five seconds; you should hear a special
"56712" sound. This confirms the start of programming
mode.
3. Setting the programming point (value):
You will hear a looped sequence of different sounds. Move the throttle stick to "full-throttle" in order to set the value. You will then hear a
special "1515" sound which confirms and stores your selection.
(Moving the throttle stick to full-throttle returns you to Step 2, and you can then select the next point. Moving the throttle stick within two
seconds quits programming mode.)
Programming points "Beep" (1 brief beep)
Brake Off
Battery type Lipo
Soft-cut
Cut-off
Cut-off threshold Low
Start mode Normal
Timing Low
8
All manuals and user guides at all-guides.com
Building and Operating Instructions - Air Trainer 140 ARF
2. Select the programming point:
When programming mode commences, you will hear a looped sequence of eight sounds. Moving the throttle stick to the neutral
position within three seconds of hearing a particular sound selects the corresponding point.
1. "beep"
2. "beep-beep-"
3. "beep-beep-beep-"
4. "beep-beep-beep-beep-"
5. "beep-----"
6. "beep-----beep-"
7. "beep-----beep-beep-"
8. "beep-----beep-----"
"Beep-Beep" (2 brief beeps) "Beep-Beep-Beep" (3 brief beeps)
On
NiMH
Cut-off
Medium High
Soft Super-soft
Medium High
Brake
Battery type
Low voltage
Cut-off voltage
Start mode
Timing
Reset to default
Quit
4. End of programming
There are two methods of quitting programming mode:
1. In Step 3 after the special "1515" beep move the throttle stick
to the "fully back" position within two seconds.
2. In Step 2 after the "Beep-----Beep-----" sound (e.g. Point #8),
move the throttle stick to the "fully back" position within three
seconds.
No. 2581
(1 brief beep)
(2 brief beeps)
(3 brief beeps)
(4 brief beeps)
(1 long beep)
(1 long, 1 brief)
(1 long, 2 brief)
(2 long beeps)