Dati Tecnici; Technical Data; Donnees Techniques; Caracteristiques Techniques - Husqvarna CR 125 2009 Manual De Instrucciones

DATI TECNICI

MOTORE
Tipo .......................monocilindrico a 2 tempi
Raffreddamento...............................a liquido
Alesaggio ..........................................mm 54
Corsa .............................................mm 54,5
Cilindrata ...................................cm
Rapporto di compressione
(a luci chiuse) .......................................8,8:1
Avviamento ................................... a pedale
DISTRIBUZIONE
Tipo............valvola lamellare in aspirazione
nel basamento e valvola H.T.S. a comando
meccanico sullo scarico
LUBRIFICAZIONE
Motore .................miscela benzina olio al 4%
durante il rodaggio; al 3%, NON MENO,
a rodaggio effettuato
Trasmissione primaria/
cambio velocità ........................mediante
l'olio contenuto nel basamento
ACCENSIONE
Tipo..elettronica analogica (WR) o digitale
(CR) a scarica capacitiva con anticipo
variabile
Tipo candela..........................."CHAMPION"
QN 84, "NGK" BR9 EG
Distanza elettrodi candela ..........0,6 mm
24
WRCR 125 2009.indd 24 WRCR 125 2009.indd 24
All manuals and user guides at all-guides.com

TECHNICAL DATA

ENGINE
Type.........................2-stroke single cylinder
Cooling............................................by liquid
Bore .................................................2.12 in.
Stroke ...............................................2.14 in.
Capacity.......................................7.61 cu.in.
3
124,82
Compression ratio
(with closed ports) ................................8,8:1
Starting .......................................kick starter
VALVE GEAR
Type...............lamellar valve on suction in
the crankcase H.T.S. valve with mechanical
control on the exhaust
LUBRICATION
Engine ...............4% (1:25) of oil-gasoline
mix during running in; NOT LESS than
3% (1:33) when running in is over
Primary drive transmission/
Gearbox..........................................by the oil
contained in the crankcase
IGNITION
Type ...............electronic analogic (WR) or
digital (CR) capacitor-discharge
type, with variable advance
Spark plug type.............CHAMPION QN 84,
NGK BR 9 EG
Gap distance.................................0.0236 in.

CARACTERISTIQUES TECHNIQUES

MOTEUR
Type............................. .un cylindre à 2 temps
Refroidissement ...... ...................... par liquide
Alésage............................................... .mm 54
Course............................................. .mm 54,5
Cylindrée .................................... .cm
Rapport volumetrique
(avec orifi ces fermés) ............................8,8:1
Démarrage ..................................... ..a pédale
DISTRIBUTION
Type ............soupape lamellaire en
aspiration dans le soubassement et soupape
H.T.S. à commande mécanique
sur l'échappement
LUBRIFICATION
Moteur ..........4% de mélange huile-essence
pendant le rodage, le rodage terminé, PAS
MOIN de 3%
Transmission princiale/
Boîte de vitesse..............par l'huile du carter
ALLUMAGE
Type.......electronique analogique ( WR) ou
digital (CR) à décharge capacitive, avec
avance variable
Bougie type ................"CHAMPION" QN 84,
"NGK" BR9 EG
Distance électrodes.......................0,6 mm
3 124,82
21-07-2008 16:44:04 21-07-2008 16:44:04