Disposing Of Packaging; Transportation And Storage; Cleaning And Maintenance - STAMOS Power2 S-MIG 100 Manual De Instrucciones

1 2
3
4
5
When inserting the wire into the guide, tense it by hand, to prevent it from uncoiling uncontrollably. Next,
insert the wire into the guide (it is important for the tip of the wire to be perfectly straight and free of burrs),
close the guide arm, put the tensioner onto the arm and screw it on with appropriate torque.
3
1
2
Remove the nozzle and the tip from the welding clamp. Uncoil the MIG welding cable, keeping it as straight
as possible. Without touching the tip of the MIG welding cable, connect the device to power supply and turn
the welder on with the main switch.
Press the button on the welding clamp (the tip of the welding clamp should be as far away as possible from
any object) and pull out about 5 cm of the welding wire.
The device is ready for welding. Check if the wire is pressed properly and, if necessary, adjust by tightening/
loosening the pressure arm.
EN
1,3. wire guide
2. welding wire
4. pressure arm
5. guiding stirrup
1. nozzle
2. tip
3. MIG welding clamp
Rev. 03.03.2017
16

4. DISPOSING OF PACKAGING

The various items used for packaging (cardboard, plastic straps, polyurethane foam) should be kept, so that
the device can be sent back to the service centre in the best possible condition in case of any problems!

5. TRANSPORTATION AND STORAGE

Shaking, crashing and turning upside down of the device should be prevented when it is transported. Store it
in a properly ventilated surrounding with dry air and without any corrosive gas.

6. CLEANING AND MAINTENANCE

• Disconnect from electricity when cleaning equipment.
• Use cleaner without corrosive substances to clean surface.
• Dry all parts well after cleaning before the device is used again.
• Store the unit in a dry, cool location, free from moisture and direct exposure to sunlight.
7. REGULAR CONTROL OF THE DEVICE
Check regularly that the device doesn´t present any damage. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
• Invoice number and serial number (the latter is to be found on the technical plate on the device).
• If relevant, a picture of the damaged, broken or defective part.
• It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. The more detailed your information, the better the
customer service will be able to answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to
a loss of warranty!
Rev. 03.03.2017
EN
17