Principle Of Operation; Before First Use; Installing The Appliance - STAMOS S-LS-1 Manual De Instrucciones

Any damage resulting from a non-conform use of the device is payable by the user!

PRINCIPLE OF OPERATION

Assembly:
3 2
4 5
6
7
1. HOT AIR temperature set buttons
2. HOT AIR temperature display
3. HOT AIR turn on / off switch
4. soldering iron turn on / off switch
5. soldering iron temperature display
6. switch between temperature units (C / F)
7. HOT AIR cable
8. air flow volume adjustment knob
9. soldering iron connection socket
10. connection metering voltage (+)
11. ground connection (-)
12. connection test voltage (+)

BEFORE FIRST USE

Upon receipt of the goods, check the packaging for integrity and open it. If the packaging is damaged, please contact your trans-
port company and distributor within 3 days, and document the damages as detailed as possible. Do not turn the package upside
down! When transporting the package, please ensure that it is kept horizontal and stable. Please keep all packaging materials
(cardboard, plastic tapes and styrofoam), so that in case of a problem, the device can be sent back to the service centre in accu-
rate condition.
Disposing of packaging
The various items used for packaging (cardboard, plastic straps, polyurethane foam) should be conserved, so that the device can
be sent back to the service center in best conditions in case of problem!

INSTALLING THE APPLIANCE

Appliance location
The work surface where the device will be located must be suitable for the size of the appliance, please refer to the measure-
ments.
The work surface must be levelled, dry, heat-resistant and at a fitting height from the ground to enable a proper use of the de-
vice.
The power cord connected with the appliance must be properly grounded and correspond to the technical details.
10
1
24
8 9
EN
23
21
14 19 16
15
10 11 12
13. switch between output / input voltage
14. output current fine adjustment knob
15. current stabilization indicator
16. output voltage fine adjustment knob
17. voltage stabilization indicator
18. output voltage coarse adjustment knob
19. output current coarse adjustment knob
20. switch between A and mA
21. current display
22. DC power supply switch on / off
23. voltage display
24. soldering iron temperature set buttons
22
20
18
17
13