Erreka PUMA PUS400EC Manual Del Instalador página 56

INSTALLATION

General connections
(ST1)
(ST2)
A.T (ST1) Total opening key command
A.P (ST2) Pedestrian opening key command
SG.C Closing safety device (mechanical strip
or photocell)
AUX Output (24Vac, 300mA)
Constant output in order to feed
peripheral devices
STOP Emergency pushbutton
DEST Flashing light (125/230Vac, max. 60W)
Connection of safety transmitter-receiver photocells in closing (SG.C)
52
Installation Manual
All manuals and user guides at all-guides.com
(ST1, start)
(ST2, pedestrian)
FC1
(DIP9=OFF: FCC)
(DIP9=ON: FCA)
ST1
COM
ST2

We recommend installing safety photocells.
1 Complete the connections as shown in the figure.
O If neither photocells nor a mechanical strip are connected,
make an electrical bridge between cable connectors (2) and (4).
FC2
(DIP9=OFF: FCA
(DIP9=ON: FCC)
A1 Operator motor
SMF Traffic light card AEPS1-001
FCC Magnetic closing limit switch (Hall effect
sensor)
FCA Magnetic opening limit switch (Hall
effect sensor)
SW1 Main switch
ANT Cable connectors for antenna
R.E Plug-in receiver
(close)
(open)
P145X