WEG CFW701 Manual Del Usuario página 31

Keypad (HMI) and Basic Programming
The keypad can be installed or removed from the inverter with or without AC power applied
to the inverter.
The HMI supplied with the product can also be used for remote command of the inverter. In
this case, use a cable with male and female D-Sub9 (DB-9) connectors wired pin to pin (mouse
extension type) or a market standard Null-Modem cable. Maximum length of 10 m (33 ft). It is
recommended the use of the M3 x 5.8 standoffs supplied with the product. Recommended
torque: 0.5 N.m (4.5 lbf.in).
Use the keypad frame accessory to assembly the keypad on the panel door or control table
(see section 7.2 ACCESSORIES on page
on page 141).
NOTE!
A list of parameters is supplied with the product, for additional information on
each parameter refer to the CFW701 programming manual provided in the
CD-ROM that accompanies the product or it can be downloaded at the WEG
homepage - www.weg.net.
26 | CFW701
Monitoring Mode
It is the initial state of the keypad after power up and startup screen,
„
with the factory default values.
The Menu is not active in this mode.
„
Main display and secondary display show the values of the parameters
„
defined at P0205 and P0206.
From the monitoring mode, pressing the ENTER/MENU key will switch
„
to the programming mode.
Programming Mode
Level 1:
This is the first level of the programming mode. It is possible to chose
„
the parameter group by using the
The main display, secondary display and variable unit are not shown
„
at this level.
Press the ENTER/MENU key to go to the level 2 of programming mode
„
- parameters selection.
Press the BACK/ESC key to go back to the monitoring mode.
„
Level 2:
The parameter number is displayed on the main display and its value
„
on the secondary display.
Use the and keys to find the desired parameter.
„
Press the ENTER/MENU key to go to level 3 of the programming mode
„
– parameters value changing.
Press the BACK/ESC key to return to level 1 of the programming mode.
„
Level 3:
The parameter values is shown at the main display and the parameter
„
number at the secondary display.
Use the and keys to change the value of the selected parameter.
„
Press ENTER/MENU key to confirm the modification (save the new value)
„
or BACK/ESC key to cancel the modification (do not save the new value).
In both cases, the keypad returns to the level 2 of the programming mode.
Figure 4.3: Keypad operation modes
37, or perform the drilling as shown in
and keys.
Figure A.5