Basic Application Menu - WEG CFW701 Manual Del Usuario

First Time Power-Up and Start-Up

5.2.2 Basic Application Menu

Step Action/Display Indication
1
Monitoring mode.
„
Press the ENTER/MENU key to get into
„
the first level of the programming mode.
3
Press ENTER/MENU when the group is
„
selected.
5
If necessary, change "P0101 – Deceleration
„
Time".
Press the
„
parameter.
7
If necessary, change "P0134 – Maximum
„
Speed" parameter.
Press the
„
parameter.
9
If necessary, change "P0136 – Manual
„
Torque Boost" parameter.
Press the
„
parameter.
30 | CFW701
or key to the next
or key to the next
or key to the next
Figure 5.2: Basic application group
Step Action/Display Indication
2
The PARAM group is selected, press the
„
or keys to select the BASIC group.
4
In this moment the Basic Application
„
routine is initiated. If necessary, change
"P0100 – Acceleration Time" parameter.
Press the
„
parameter.
6
If necessary, change "P0133 – Minimum
„
Speed" parameter.
Press the
„
parameter.
8
If necessar y, change "P0135 – Max.
„
Output Current" parameter.
Press the
„
parameter.
10
Press the BACK/ESC key to end the Basic
„
Application routine.
Press the BACK/ESC again to go back to
„
the monitoring mode.
or key to the next
or key to the next
or key to the next