cecotec CONGA POPSTAR 29600 AQUA&COLLECT Manual De Instrucciones página 42

ENGLISH
2. Press the On/Off button to start using the device. The device will operate at low power
level by default.
3. Press the speed button to switch between high and low power level.
4. Press the On/Off button to turn the device off.
5. After pressing the On/Off button, press and hold the water spray button. The spray
nozzle on the floor brush sprays water to wet the rolling brush body.
6. Release the water spray button for the device to stop spraying.
Notes:
Do not vacuum foam liquid with the product, nor put high-foam cleaning solution into the
water tank.
It is recommended to use the high power level when the environment is heavily polluted or
when there are many water stains.
When the sewage tank is full of water, the indicator light will flash green and the main motor
will stop working.
Fig. 8
1. On/Off
2. Speed button
3. Spray button
Emptying the sewage tank
1. Gently press the sewage tank release button on the sewage tank and remove the sewage
tank.
2. Hold the body of the sewage tank in one hand and pull out the upper cover of the sewage
tank with the other hand.
3. After the sewage in the sewage tank is emptied, be sure to clean the sewage tank. Place
the cover of the sewage tank in place and install the sewage tank back into the machine
body.
4. Click it into place to ensure it is properly installed.
Fig. 9
Product charging
Connect one end of the charger to the main frame and the other end to the home socket (the
red light is always on when charging, and the green light is always on when it is fully charged).
When charging, the whole machine shall be placed on the charging stand, close to the wall
corner, so as to avoid tripping and other injuries
Note:
It is best not to plug the charger into the plug for a long time, to prevent children touching it etc.
Fig. 10
42
CONGA POPSTAR 29600 AQUA&COLLECT