Ryobi P3650 Manual Del Operador página 16

WARNING:
Make sure the spindle lock button is not engaged before
reconnecting saw into power source. Never engage
spindle lock button when blade is rotating.
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
USING THE LASER GUIDE LINE
See Figure 14.
NOTE: Before you can align the laser guide, you must install
the battery packs as described in the Operation section of
this manual.
Lock the switch by installing a padlock (not included) through
the hole in the switch trigger and closing the shackle.
Using a square, draw a straight line on the workpiece. When
the laser guide button is turned on it will generate a red line
on the work surface. This line will let you see your mark and
the laser guide line at the same time, and will assist you in
lining up the mark for more accurate cutting of the workpiece.
NOTE: The broken line may begin slightly skewed off of the
mark in the uppermost position. As the saw blade assembly
is lowered, at the approximate point the lower blade guard
starts to move, the laser line will be aligned with the mark and
remain aligned throughout the cut. This is normal. NEVER
attempt to move the workpiece while making a cut. Always
keep hands outside the "No Hands Zone".
With the saw arm at the uppermost position, move the
workpiece until the mark and the laser line are aligned. Once
both lines are in alignment, do not move the workpiece.
Clamp the workpiece.
Remove the padlock. Make several practice cuts on different
styles and thickness of material. Repeat the steps above as
necessary.
Removing Your Mark:
Position the workpiece so that the laser line is near the left
edge of your mark in order to remove the mark.
To Cut Your Mark:
Position the workpiece so that the laser line is near or over
your mark in order to cut the mark.
To Leave Your Mark:
Position the workpiece so that the laser line is near the right
edge of your mark in order to leave the mark.
All manuals and user guides at all-guides.com
ASSEMBLY
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning your mark with the laser line.
To adjust the position of the laser guide line, refer to the
Adjustments section later in this manual.
16 − English
• To reduce the risk of injury, user must read and understand the
operator's manual before using the miter saw.
• Wear eye protection.
• Keep hands out of path of saw blade.
• Do not operate saw without guards in place.
• Do not perform any operation freehand.
• Never reach around the saw blade.
• Turn off tool and wait for saw blade to stop before raising saw
LASER
arm, moving workpiece, or changing settings.
• Disconnect the saw from the power source before changing blade
GUIDE or servicing.
RYLD
BUTTON
RED
LINE
Complies with 21 CFR
Parts 1040.10 & 1040.11
LASER RADIATION AVOID DIRECT EYE EXPOSURE
CLASS IIIa LASER PRODUCT
MAXIMUM OUTPUT: <5mW WAVELENGTH: 635-660nm
Lock trigger prior to adjusting
laser. AVOID EXPOSURE:
Laser radiation is emitted from this aperture.
Fixer gâchette avant
làser est réglagé. EVITER
L'EXPOSITION: Rayonnement laser émise de cet orifice.
Asegure gatillo antes de ajuste
de laser. EVITE LA EXPOSICIÔN:
Radiación laser se emite por esta abertura.
Fig. 14