Making An Auxiliary Fence - Ryobi P3650 Manual Del Operador

 Push the saw handle away from you and toward the bevel
scale at the back of the saw.
 Release the switch trigger and wait until the electric brake
stops the blade from turning before raising the blade out
of workpiece and removing the workpiece from the miter
table.
NOTE: A cross cut is made by cutting across the grain of
the workpiece. A straight cross cut is made with the miter
table set at the 0° position. Miter cross cuts are made with
the miter table set at some angle other than 0°.
TO SUPPORT LONG WORKPIECES
See Figure 34.
Long workpieces need extra supports. Supports, roller stand,
or work surface level with the saw table should be placed
along the workpiece so it does not sag. The support should
let the workpiece lay flat on the base of the saw and work
table during the cutting operation. Use the work clamp,
C-clamp, or other suitable clamp to secure the workpiece
when possible.

MAKING AN AUXILIARY FENCE

See Figure 35.
Depending on the size and position of the workpiece, certain
unusual cuts may benefit from the additional support that can
be provided by an auxiliary fence. The holes provided in the
miter fence are used to secure an auxiliary fence in place.
NOTE: The auxiliary fence can only be used when the bevel
is set at 0°. When making a bevel cut, the auxiliary fence
MUST be removed.
To attach the auxiliary fence to the saw:
 Place the 10 in. long piece of wood against the miter
fence and aligned with the left edge of the miter table.
NOTE: The appropriate height and thickness of the fence
will vary based on the miter angle and the material being
cut.
 Clamp the wood tightly against the fence and drive wood
screws from the back of the fence through the two holes
and into the auxiliary fence. If necessary, drill a pilot hole
into wood first to prevent splitting. Remove clamp when
finished.
NOTE: Make sure the screws you use to attach the
auxiliary fence do not pass through the front face of the
fence and the length of the screws will not put them in
the path of the blade at any angle.
 Make full left miter cut through the auxiliary fence.
NOTE: Check for interference between the auxiliary fence
and the lower blade guard. Correct any interference
before proceeding.
 Repeat steps with second board by aligning with right side
of miter table and making a full right miter cut through
the auxiliary fence.
All manuals and user guides at all-guides.com
OPERATION
25 − English
LONG
WORKPIECE
WORKPIECE
SUPPORTS
Fig. 34
AUXILIARY
FENCE
ALIGN BOARD
WITH EDGE OF
MITER TABLE
Fig. 35