Ryobi P3650 Manual Del Operador página 19

INDICATOR
SCREW
SCALE
INDICATOR
MITER
SCALE
SQUARING THE BLADE TO THE MITER TABLE
See Figures 23 - 25.
 Remove the battery packs from the tool.
 Pull the saw arm all the way down and engage the lock pin
to hold the saw arm in transport position.
 Loosen the miter lock knob approximately one-half turn and
squeeze the detent release lever.
 Rotate the miter table until the scale indicator on the miter
table is positioned at 0°.
 Release the detent release lever, engaging the positive stop
notch, then tighten the miter lock knob to secure the miter
table.
 Loosen the bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Place a combination square against the miter table and the
flat part of saw blade.
NOTE: Make sure that the square contacts the flat part of
the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be parallel
as shown in Figure 23.
 If the top or bottom of the saw blade angles away from the
square as shown in Figures 24 and 25, adjustments are
needed.
 Loosen bevel lock knob.
 Adjust positive stop adjustment screw to bring saw blade
into alignment with the square. See Positive Stop Adjust-
ment in the Adjustment section.
 Tighten bevel lock knob. Recheck blade-to-table alignment.
NOTE: The above procedure can be used to check blade
squareness of the saw blade to the miter table at both 0°
and 45° angles.
Your saw has several scale indicators. After squaring adjustments
have been made, it may be necessary to loosen the indicator
screws and reset them to zero. See Figures 21 - 22.
All manuals and user guides at all-guides.com
ASSEMBLY
Fig. 22
19 − English
MITER
FENCE
COMBINATION
SQUARE
CORRECT VIEW OF BLADE
SQUARE WITH MITER TABLE
MITER
FENCE COMBINATION
SQUARE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED
MITER
MITER
TABLE
FENCE
COMBINATION
SQUARE
VIEW OF BLADE NOT SQUARE WITH MITER TABLE,
ADJUSTMENTS ARE REQUIRED
MITER
BLADE
TABLE
MITER
LOCK HANDLE
Fig. 23
MITER
TABLE
BLADE
Fig. 24
BLADE
Fig. 25