Technical Data - EINHELL ROYAL DSP 5 Manual De Instrucciones

Anleitung DSP 5 13.11.2001 10:56 Uhr
Safety instructions:
Wear safety gloves!
Wear goggles!
Beware of inflammable
materials or high temperature!
Before long periods of non-use, clean the spray
thoroughly with water. Take out the pump to
enable the tank to dry. Use no solvents or caustic
agents for cleaning.
After use, empty the pump and do not leave
under pressure.
Clean the pump thoroughly each time after use.
Protect brass components from freezing
temperatures and do not expose to ammonia as
found e.g. in stable vapours and certain types of
fertilizer.
Check that the safety valve works properly.
Replace any damaged parts of the spray
immediately. Use only original Einhell parts.
Depressurize the spray before carrying out any
repairs. Repairs and modifications to the tank are
prohibited.
The German Farming Association recommends
having the spray checked after five years by a
specialist, preferably the manufacturer.
Do not blow out clogged nozzles or valves with
your mouth. When you unscrew the spray tube,
be sure to point its end away from you.
Note the wind direction when spraying. Never
spray into the wind.
Do not leave the spray in the sun.

Technical data:

Max. capacity:
Operating pressure:
Liquid temperature max.:
Putting into use:
1. Connect the hose to the tank and to the handle
and secure with the union nut.
2. Open the tank by turning the pump handle
anticlockwise.
3. Fill the tank.
4. Screw in the pump handle again by turning
clockwise.
Seite 3
5. With pumping movements of the pump handle
you can now raise the pressure inside the tank.
6. Before starting to spray, latch the pump handle in
place by twisting slightly in clockwise direction.
Spraying:
To spray, press the lever on the handle. Release
the lever and the spraying is interrupted
immediately.
If the pressure drops while you are spraying you
can raise the pressure again inside the tank by
pumping with the pump handle.
You can let the residual pressure out of the tank
by pulling the red safety valve.
Media:
The DSP pressure spray is designed for use with
pesticides. At the time of its production the
manufacturer knew of no negative effects on the
equipment's fabrication materials from pesticides
approved by the German Biological Institute
(BBA).
The pressure spray is not suitable for solvents,
caustic materials (e.g. disinfectants, impregnants
and carbolineum) or substances hotter than
30°C.
Media other than pesticides may be used only if
you can rule out all risk of detrimental effects on
the equipment's fabrication materials.
Orders for replacement parts:
Please quote the following data when ordering any
replacement parts:
Type of appliance
Article No.
Ident No.
Replacement part No. of the part required
We draw express attention to the fact that we are not
5 litres
liable under the Product Liability Law for any damage
max. 3 bar
caused by our appliances if said damage results
30°C
from improper repair or if parts are replaced by non-
original Einhell parts or parts not issued with our
approval and the repair was not carried out by ISC
Customer Service.
GB
3