Electrolux EWF 14118 Folleto De Instrucciones página 19

10. Start the programme
Press the Start/Add clothes button. The relevant light
will stop flashing. The message relevant to the phase
that is in progress will be shown in the display.
If you have chosen a delayed start, the washing
machine will begin the countdown.
11. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the Start/Add clothes
button .
It is possible to change any phase before the
programme carries it out.
When the programme has started, you can only
reset it by turning the programme selector dial to
off« » and then you can select the new
programme. The washing water remains in the
tub.Start the new programme by depressing the
Start/Add clothes button
Note: To drain the water before starting the new
cycle you have to cancel the programme and select
the DRAIN cycle.
12. Cancelling a programme
Turn the selector dial to off«
programme which is running. Now you can select a
new programme.
13.How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE phase, by pressing Start/Add
clothes button provided the following conditions
exist:
1) the washing machine is not in the heating phase
beyond 55°C
2) the level of the water is not high;
3) the drum is not turning.
1-25 ES Mac64.indd 19 1-25 ES Mac64.indd 19
All manuals and user guides at all-guides.com
COTTON 08.30
Washing 12.00
40°C 1200
Exit
Temp. Spin Options Change
.
» to cancel a
19
19
If these requirements are met, when you pause the
washing machine, the relevant message appears in
the display, the door locked light goes out and the
door can be opened.
Should it not be possible to open the door, the door
locked light is on should it be absolutely necessary to
do so, switch the machine off by turning the selector
dial on " " position.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
14. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal (if option
no sound has not been selected), and displays the
relevant message.
If you had selected the RINSE HOLD or NIGHT
CYCLE option, the Start/Add clothes button
is off and the door locked light is on.
To drain or spin first turn the programme selector dial
to off« » and then to drain
spin / delicate spin programme.
Release of the lock is also indicated by the coming
on of the message "Door openable" (cycle ended)
and the going out of the door locked light.
Turn the programme selector dial to off«
switch the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking) or
bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
light
programme or
» to
3/4/06 12:45:46 AM 3/4/06 12:45:46 AM