Line In Mode - Silvercrest SBLL 4.2 A1 Manual De Instrucciones

SilverCrest SBLL 4.2 A1

LINE IN mode

In LINE IN mode you have to connect the speaker to
your audio source with a cable. Proceed as follows:
 Turn your audio source down to a low volume.
 Connect the supplied audio cable (C) to the LINE IN
jack (8) and your audio source. Please note: An
acoustic signal is played if the audio cable (C) is
connected or disconnected while the speaker is on.
 Turn the speaker on by setting the ON/OFF switch
(6) to the 'ON' position. You will hear a series of
sounds that gradually increase in volume. 'bLUE' is
shown on the display (1).
 Briefly press the M button (3) twice to change to
LINE IN mode. The display (1) shows 'LINE' and
'AUX.'
 Adjust the volume on your audio source or using the
button (4) and
so, the volume setting is briefly shown on the display
(1).
 You can turn the speaker off by setting the ON/OFF
switch (6) to the 'OFF' position.
The buttons on the speaker perform the following
functions in LINE IN mode:
Function
Mute or unmute
Volume up*
38 - English
button (5). When you do
Action
Briefly press the
button (2)
Hold down the
button (5)