Publicidad
Assembly Instructions
Before assembling or using the table-tennis table, please read the following instructions carefully. They contain impor-
tant information for use and maintenance of the equipment as well as for your personal safety. Keep these instructions
in a safe place for maintenance purposes or for ordering spare parts.
All KETTLER products are designed in accordance with the latest safety regulations and undergo a constant process of quality control
during manufacturing. The knowledge gained in this process is used to constantly improve and develop our products. In order to offer
our customers the very best in product quality, we reserve the right to make technical changes at any time. In spite of this, should you
have any cause for complaint, please contact your KETTLER dealer.
Note on Safety
The table-tennis table should be used only for its intended pur-
pose, i.e. for playing with suitable table-tennis bats and balls.
All other uses are prohibited and may be dangerous. The man-
ufacturer cannot be held liable for damage or injury caused by
improper use of the table.
Damaged or worn components may endanger your safety or
shorten the lifespan of the table-tennis table. Replace worn or
damaged components immediately and remove the table from
use until this has been done. Use only spare parts manufactured
by KETTLER.
The table-tennis table complies with all safety regulations. In-
correct repairs, alterations to the design (removal of original
parts, addition of other components etc.) may endanger the
safety of the user.
Instruct other persons (in particular children) using the table in
its correct use, and draw their attention to any potential source
of danger, especially when setting up or dismantling the table.
Handling the equipment
Do not use the table-tennis table until it has been fully and cor-
rectly assembled and checked.
Ensure that table-tennis tables which are not weatherproof are
not exposed to dampness or rain. Keep them well away from
direct sources of heat. Should the surface become warped, lay
the table on a level surface for a few days.
Set the table up on a level surface.
Do not cover it with plastic foil, under which condensation may
form. We recommend the weatherproof KETTLER tarpaulin, art.
no. 7032-300.
Instructions for Assembly
The equipment must be assembled with due care by two adult
persons.
Before assembling the equipment, study the drawings carefully
and carry out the operations in the order shown by the dia-
grams. The correct sequence is given in capital letters.
Please note that there is
always a danger of injury when work-
ing with tools or doing manual work. Therefore please be care-
ful when assembling this machine.
Ensure that your working area is free of possible sources of
danger, for example don't leave any tools lying around. Al-
ways dispose packaging material in such a way that it may not
cause any danger. There is always a
dren play with plastic bags!
The fastening material required for each assembly step is
shown in the diagram inset. Use the fastening material exactly
as instructed.
Bolt all the parts together loosely at first, and check that they
have been assembled correctly. Tighten the locknuts by hand
until resistance is felt, then
completely against resistance (locking device).
all screw connections have been tightened firmly.
once locknuts have been unscrewed they no longer function
correctly (the locking device is destroyed), and must be re-
placed.
risk of suffocation
use spanner to finally tighten nuts
Then check that
Attention:
Caution: While assembly of the product keep off children's
reach (Choking hazard - contains small parts).
When setting up or dismantling the table, stay clear of its fold-
ing radius.
When folded up, the table-tennis table presents a large surface
to the wind. For this reason, ensure that it is stored in a shel-
tered position.
The table-tennis table may be pushed only into the transport po-
sition because there is otherwise a danger of injury.
The unit complies with the standard EN 14468–1:2004.
Depending on frequency of use, check all screws, bolts etc. reg-
ularly to ensure that they are in good condition.
Caution: While assembly of the product keep off children's
reach (Choking hazard - contains small parts).
In case of enquiry, please contact your KETTLER dealer.
For practising without a partner, the table halves can be folded
up singly.
For more information on the sport of table-tennis, you are re-
ferred to the specialist literature on the subject.
Do not use corrosive or abrasive materials to clean the equip-
ment. Ensure that such materials are not allowed to pollute the en-
vironment. In most cases, a slightly dampened cloth is sufficient.
Waste Disposal: KETTLER products are recyclable. At the end of
its useful life please dispose of this article correctly and safely
(local refuse sites).
Ensure that you have received all the parts required (see check
list) and that they are undamaged. Should you have any cause
for complaint, please contact your KETTLER dealer.
For technical reasons, we reserve the right to carry out prelim-
inary assembly work (e.g. addition of tubing plugs).
Please keep original packaging of this article, so that it may be
used for transport at a later date, if necessary. Goods may only
be returned after prior arrangement and in (internal) packa-
ging, which is safe for transportation, in the original box if pos-
sible. It is important to provide a detailed defect description /
damage report!
List of spare parts
if chil-
When ordering spare parts, always state the full item number,
spare-partnumber, the quantity required and the S/N of the pro-
duct (see spare parts drawing).
Example order: Art. no. 7176-000 / spare-part no. 94130003 /
2 pieces / S/N......
Important: spare part prices do not include fastening material; if
fastening material (bolts, nuts, washers etc.) is required, this
should be clearly stated on the order by adding the words
"with fastening material"
KETTLER GB Ltd.· KETTLER House, Merse Road · North
GB
Moons Moat · Redditch, Worcestershire B98 9HL
Publicidad
