Setting Up; Preparing The Ova+ Unit; Using The Ova - TensCare Ova+ Instrucciones De Uso

11. SETTING UP

11.1. PREPARING THE OVA+ UNIT

1) To test that the battery is charged (see section 8) and that the unit is
working press and hold the "
The display should appear, and an audible "Beep" will be heard.
Press and hold the "
2) Connect the Y-cable to the unit.
3) Connect the electrode pad "pigtail" connections to the Y-cable.
4) After the wires are securely connected, separate the electrodes from
the backing and apply as described in sections 12 & 13.
Caution:
connecting/disconnecting the leads or applying/removing the
electrodes from the skin.

11.2. USING THE OVA+

1) Once the electrode pads are in place, press and hold the "" button
on the control unit for 3 to 5 seconds to switch the control unit on.
2) When switched on for the first time, the Ova+ will automatically select
the Mode 0. After that it will automatically select the programme you
were using the last time it was switched off.
3) You can select from the four pre-set programmes. Details in section 7
will help you identify the best programme to suit you.
4) With the required programme selected, you can adjust the intensity of
the stimulation until you reach a comfortable level.
Note: If the sensation becomes uncomfortable, reduce the
intensity.

" button for at least three seconds.

" button to turn off the unit.
Ensure the
17
device is OFF before