Setting Up And Using The Perfect Tens; Installation Of Batteries - TensCare perfect Tens Manual Del Usuario

11. SETTING UP AND
USING THE PERFECT
TENS
11.1. INSTALLATION OF
BATTERIES
1) Remove belt clip by sliding down.
2) Remove battery cover by pulling on
tag.
3) Insert batteries.
Ensure that the batteries are inserted
the right way as shown in battery
compartment and that the ribbon is
behind them.
4) Replace battery cover and belt clip.
When the
running low, a low battery
indicator will show on the
screen and it is important to change the
batteries as soon as possible.
Rechargeable batteries
The unit will work with rechargeable
batteries, but the display may appear
dim.
Storage
Remove batteries from your perfect
TENS if the unit is unlikely to be used
for a long period. Some types of
batteries may leak corrosive fluid.
Battery Life
Batteries should last about 48 hours at
full power.
Unused batteries have a nominal shelf
life of 3 years, but will usually last longer
than this.
Battery Warnings
and/or corrosive environment.
direct strong sunlight, in a high
temperature location, in a pressurized
container or in a microwave oven.
batteries are
If battery leakage occurs and comes in
contact with the skin or eyes, wash
thoroughly with lots of water.
Keep batteries out of the reach of small
children.
18
Do NOT pierce,
disassemble, or use in a humid
Do NOT expose
temperatures over 60°C(140F).
Do NOT put, store
leave near sources of heat, in
Do NOT immerse in water or
sea water, or get wet.
Do NOT short-circuit.
Do NOT connect the device
unless the battery cover is in
place.
open,
to
or