Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
To turn the unit on, place the mains switch to position "I". Fig.
7 (Only for models 830.01/RTL, 830.02/RTL).
To start the hairdryer, remove the handpiece from its housing.
Models 830.01/R and 830.02/R are fitted with 110-120V and
220-240V, 50/60 Hz~ shaver sockets.
These sockets, which can be accessed by lifting a special
protection flap (fig. 6), must only be used to run or recharge
electric shavers (max 20VA).
IMPORTANT: never connect other appliances such as electric
coffee machines, heaters, etc. to these sockets. Models
830.01/T and 830.02/T are fitted with an electric timer which
turns the appliance off automatically after a pre-set time (8
min.). To turn it back on again, simply replace the handpiece in
its housing and then remove it again.
When not in use, the mains switch on the wall holder should
be in the "0" position. (only for the models equipped with
mains switch).
CLEANING AND MAINTENANCE
Plastic components must be cleaned using a cloth damped in
warm water.
WARNING: do not use abrasive products or chemical
detergents.
A slight yellowing of the flexible hose after a few months of
use is normal and will not impair operation of the appliance.
INSTRUCTIONS FOR INSTALLATION
WARNING: this operation must be carried out by a qualified
technician.
Check that the local power supply corresponds with the one
indicated on the rating plate.
The power supply network to which the appliance is
connected must be fitted with a omnipolarebeli switch.
The appliance is destined for assembly and installation on a
wall only (vertical). The correct direction of installation is
with theextending pipe outlet at the bottom.
This hairdryer is an approved product with protection
degree IP24 (EN60529). For installation specifications,
please refer to national regulations on the use and
installation of appliances with IP24 protection from
splashing. If the power cable with plug fitted to the
appliance is used, the power socket to which it is connected
must be out of reach of possible water splashes.
Mounting sequence
1. After establishing the position in which the appliance is to be
installed, drill 3 holes Ø 6 mm in the wall as shown in fig. 1.
2. Dismantle the "T" bracket from the back of the appliance, as
shown in figure 2.
3. If the appliance is to be connected directly to the power
supply, the power cable fitted to the hairdryer must be
disconnected. When installing in this way it is necessary to
provide an all-polar disconnection switch with a contact
opening ≥ 3mm upstream of the appliance. Pass the cables
from the mains through one of the two holes "A" or "B" in the
"T" bracket and fix them to the terminal (fig.3). (Land N)
4. Fix the "T" bracket to the wall using the screws and plugs
provided (fig. 4).
5. Hang the appliance on the "T" bracket and fix it at the bottom
using the screw provided (fig. 5).
All manuals and user guides at all-guides.com
5
GUARANTEE
VALERA guarantees the appliance you have bought at
following conditions:
1. The guarantee conditions for this appliance are as defined by our
dealer in the country of sale. In Switzerland and in the countries
subject to the European directive 44/99/CE the guarantee period
is 24 months for domestic use and 12 months for professional
or similar use. The guarantee period starts from the date of
purchase as stated on the present guarantee card regularly filled
out and stamped by the dealer or on the sale's invoice.
2. The guarantee is applicable only against submission of the
present guarantee card or the sale's invoice.
3. The guarantee covers the elimination of all defects arisen during
the guarantee period resulting from proven faults in material or
workmanship. The elimination of the defects will be made either
by repairing the appliance or exchanging it. The guarantee does
not cover any damage arising from incorrect connection to the
power supply, improper use, breakage, normal wear and non-
compliance with the Instructions for Use.
4. All other claims of any nature, including those for eventual
damages outside of the appliance, are excluded, unless our
liability is legally mandatory.
5. The guarantee service is carried out free of charge; it does not
affect the expiry date of the guarantee.
6. The guarantee becomes void if repairs are under-taken by
unauthorized persons.
For UK only: this guarantee in no way affects your rights under
statutory law.
In case of defect, please return the appliance well packed and
together with the guarantee card regularly dated and stamped
to one of our Valera Service Centres or to the dealer who will
send it to the official importer for the guarantee service.
The symbol
on the product or on its packaging indicates
that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed
information about recycling of this product, please contact
your local city office, your household waste disposal service
or the shop where you purchased the product.
VALERA is a registered trade mark
of Ligo Electric S.A. - Switzerland
Publicidad
Tabla de contenido
