Diagnostic Tests - Rimage Professional 5100N Manual De Instrucciones

All manuals and user guides at all-guides.com
Rimage Professional 5100N and 5300N User Guide

Diagnostic Tests

This section provides the information needed to access, select, and perform
Rimage 5100N or 5300N diagnostic tests. To perform any of the diagnostic tests,
you must be sure that the Rimage 5000N is not in an error state.
Access Diagnostic Test Mode
1. Power on the Rimage 5000N.
2. Allow the system to fully initialize.

Note: Initializing the 5000N can take up to 5 minutes.
3. Open the front door.
4. Press and hold the operator button until the operator panel displays
[BUTTON DIAGNOSTIC].

Note: Other status messages display on the operator panel while the
operator button is being held in. Do not release the button until the
operator panel displays [BUTTON DIAGNOSTIC].
5. Release the operator button. The autoloader is in diagnostic test mode.
Select a Diagnostic Test
1. Press the operator button the same number of times as the test number
(indicated in the test title).
2. Hold the button in on the last press to start the selected test.
For example, to start Diagnostic Test 3 (Calibrate Diagnostic Test), press the
operator button three times and hold it on the third press.

 T ip: To display each diagnostic test number and name, press the
operator button at a rate that is slow enough so that you can read the
test on the operator panel. If you hold the button too long, the test starts.
2. Continue with the desired diagnostic test.
18 2000447_C