Safety Precautions - OHAUS TD52 Serie Manual De Instrucciones

Zebra Label Printer Configuration
1. Introduction
This guide is to help set up an OHAUS Ranger 7000 or Defender 5000 (TD52 series) with a Zebra® printer for
label printing. Please read this manual completely before installation and operation.
This configuration has been tested with a Zebra GC420t and GK888t but should be compatible with any Zebra
printer sharing the ZPLII programming language. The Zebra Printer used must support ZPL commands.
As label formats and barcode requirements can be highly customized, this guide is not intended as a tutorial on
how to customize further the labels printed by the Zebra printer. For additional support for Zebra printers and
label formats, contact Zebra directly at www.zebra.com.

1.1. Safety Precautions

For safe and dependable operation of this equipment, please comply with the following safety
precautions:

Verify that the input voltage range printed on the data label matches the local AC power to be used.

Make sure that the power cord does not pose a potential obstacle or tripping hazard.

Use only approved accessories and peripherals.

Operate the equipment only under ambient conditions specified in these instructions.

Disconnect the equipment from the power supply when cleaning.

Do not operate the equipment in hazardous or unstable environments.

Do not immerse the equipment in water or other liquids.

Service should only be performed by authorized personnel.

The OHAUS Ranger and Defender scales are supplied with a grounded power cable. Use only with a
compatible grounded power outlet.

Refer to OHAUS manuals for the Defender 5000 (TD52 series) and Ranger 7000 for more information.
EN-1