JBL PROTEMP
Technical data
Type
Power supply cable (1)
Switching power supply (2)
Voltage AC Input
Switching power supply (2)
Voltage DC Output
Switching power supply (2)
Power
Heating cable supply line
(4a) length
Heating cable heating
wire (4c) wattage
Heating cable heating
wire (4c) length
Mounting suction cup (5)
quantity
Aquarium
Aquarium
NOTE
• Installation can be carried out only in empty aquarium without substrate.
• The heating cable (4) has a certain length of cold, non-heating supply line (4a) on both sides. The
transition from the cold supply line to the heating part is indicated by a marking (4b) on the line.
Initial operation
Installation in the aquarium
1. Clean the bottom panel of the aquarium from the inside (dust-free).
Lay the heating wire (4c) in loops at an equal distance of approx. 8 – 10 cm on the bottom panel
(Fig. 3) by using the enclosed mounting suction cups (5). Make sure the heating wires (4c) do not
crisscross or kink. Moisten the suction cups slightly beforehand for better adhesion.
2. Lead the two cold supply lines (4a) out of the aquarium.
8
b10, b20, b40, b60
®
b10
PROTEMP
PROTEMP
®
35 W
10 W
3.6 m
20 x
40-120 L
40-80 cm
Substrate Heater
b20
PROTEMP
®
1.5 m
230-240 V / 50-60 Hz
24 V
2 m
20 W
40 W
4.9 m
30 x
60-200 L
90-300 L
60-100 cm
80 – 120 cm
b40
PROTEMP
®
®
60 W
60 W
7 m
9 m
30 x
40 x
300-600 L
120 – 200 cm
en
b60