Denon DRR-F101 Instrucciones De Operación página 12

ENGLISH
(6) Timer functions (when connected to the DRA-F101)
The timer functions of the receiver (DRA-F101) can be used to play cassette tapes or record radio programs ("Air
2
Check") at set times.
• Refer to the operating instruction included with the DRA-F101.
(7) Editing functions (when connected to the DRA-F101 and DCD-F101)
Use this function to automatically edit the tracks on the CD to fit on the tape to be used for recording.
2
The editing function is set from system remote control unit (RC-927) included with the receiver (DRA-F101).
2
DRA-F101 (receiver)
MEMORY TUNING SOURCE
FUNCTION TONE TIMER RDS / SET DOWN UP BAND DIRECT
SYSTEM
ON / STANDBY
PHONES
AM-FM STEREO RECEIVER DRA-F101
1
DRR-F101 (this unit)
2 2
e
ON / STANDBY
DOLBY NR
CD SRS REC 0 PLAY 1
ON
OFF
DCD-F101 (CD player)
3 3
ON / STANDBY
REPEAT
TRACK
RC-927 (system remote control unit)
OFF ON
1
SYSTEM
POWER
PROG /
DIRECT
1 2 3
CALL
4 5 6
CLEAR
7 8 9
RANDOM REPEAT
10 +10
CD SRS
TAPE MD TIME EDIT
TIME/
DIMMER
PANEL
12
Turn on the power of the receiver.
• The system's power turns on.
VOLUME
SYSTEM
ON / STANDBY
1
(DRA-F101) (System remote control unit)
Load the cassette tape onto which
2
you want to record into the DRR-
F101's cassette holder.
PLAY
CD SRS REC
3
Load the CD in the DCD-F101.
REVERSE
MODE
CASSETTE DECK DRR-F101
Now operate as described in the "Editing
4
Function" section of the operating instructions
included with the CD player (DCD-F101).
COMPACT DISC PLAYER DCD-F101
NOTES:
• The editing function will not work with discs containing more than 21 tracks.
• Load the cassette tape onto which you want to record into the cassette deck's cassette tray with side A facing up
before starting edited recording. The beginning of the tape is automatically found before recording starts.
• When using a recorded cassette tape for edited recording, recording stops and a blank section is left on side B of
the tape if the tape is longer than the set time, so erase the tape beforehand.
• When the editing function is used for recording, set the reverse mode switch to
record on side B after side A.
• In some cases it may not be possible to record all the tracks on the disc, even if the tape is longer than the disc's
recorded time (because of how the tracks are divided onto sides A and B of the tape). The "OVER" indicator on
the CD player flashes if there are tracks that cannot be recorded.
• Recording button (REC),
function during editing.
• When recording using the editing function, the CD player's auto space function is activated and blank spaces of
ON
SYSTEM approximately 4 seconds are automatically created between tracks. Because of this, when recording CDs
POWER
containing for example recordings of concerts without spaces between tracks, blank spaces will be created in the
middle of the piece. In this case, do not record using the editing function.
• To cancel the editing mode, press the stop button (
CD. The editing mode is not canceled if other buttons are pressed.
(Main unit)
(DCD-F101)
button, CD SRS button, DIRECTION button and OPEN/CLOSE button will not
6 7
) on the DRR-F101 or the CD player to stop playback of the
2
if not, it is not possible to