Dyna-Glo DGA550SSP Manual De Instrucciones página 9

ASSEMBLY INSTRUCTIONS
8. Attach the cart rear panel (F) by sliding the
keyholes in the cart rear panel (F) over the
inserted screws. Slide the cart rear panel (F) down
to meet bottom shelf (A). Secure the cart rear
panel (F) to the bottom shelf (A) with three screws
(AA). Tighten all screws, including the two screws
in cart side panels (D & E).
Hardware Used
AA
M6x12Screw
9.  P artiallyinsertfourM6x12screws(AA)intothe
cart side panels (D & E). Attach the upper door
brace (G) by sliding the cut-outs in the upper door
brace (G) over the four screws (AA) and tightening
all four screws (AA).
Hardware Used
AA
M6x12Screw
10.   R emovepreassembledM4x10screws(GG)
from the door handles (J). Insert two door handle
sleeves (K) into the holes located on the back
oftheleftdoorassembly(H).InserttwoM4x10
screws (GG) into the door handle sleeves (K)
and into the threaded holes in the door handle
(J). Tighten the screws. Repeat with right door
assembly (I).
Hardware Used
GG
M4x10Screw
All manuals and user guides at all-guides.com
x3
x4
x4
10
8
1
D
A
E
2
AA
2
2
9
AA
1
1
E
2
G
2
10
1
1
GG
J
K
F
1
D
H