Tech Specs - Slime 40066 Manual Del Usuario

Compresor multiusos
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CAUTION: HOT! DO NOT OVER INFLATE. DO NOT HOLD IN HAND WHILE OPERATING.
PLACE INFLATOR ON A HARD, CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in
"accessory" or "on" position. Please make sure emergency brake is set and car is
in park.
2. Always ensure air hose chuck touches the core of the valve stem for proper
inflation.
3. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inflator unattended.
4. Always use a pressure gauge to check tire pressure. DO NOT overinflate.
5. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure
markings. Be careful not to inflate items beyond their capacity.
6. While operating, never block the inflator input or output.
7. Keep inflator out of reach of children.
8. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with
older 8 amp cigarette lighter receptacles.
TECH SPECS
TIRE INFLATION TIME
MATTRESS INFLATION TIME
HIGH PRESSURE CFM
HIGH VOLUME CFM
DIAL GAUGE
POWER SOURCE
REPLACEABLE FUSE
POWER CORD LENGTH
HIGH PRESSURE AIR HOSE LENGTH
HIGH VOLUME AIR HOSE LENGTH
TOTAL REACH
LED LIGHT
* (0-35 PSI, Standard Tire: P195/65 R15)
8 min*
3 min**
0.70 (19.8 LPM)
1.30 (36.8 LPM)
0-100 PSI (0-7 BAR)
12 volt accessory power outlet
5mm x 20mm 250V 15A
10.2ft. (3.10m)
2.30ft (70cm)
1.30ft (40cm)
12.5ft. (3.80m)
210 lumens @ 300mm
**Twin air mattress

Publicidad

Tabla de contenido
loading

Tabla de contenido