How Ua-704 Works; Before You Start - AND UA-704 Manual De Instrucciones

?

HOW UA-704 WORKS

LifeSource™ Blood Pressure Monitors are easy to use, accurate
and digitally display full measurement readouts. Our technology is
based on the "oscillometric method" — a noninvasive blood pres-
sure determination. The term "oscillation" refers to any measure
of vibrations caused by the arterial pulse. Our monitor examines
the pulsatile pressure generated by the arterial wall as it expands
and contracts against the cuff with each heartbeat.
The cuff is inflated until the artery is fully blocked. The inflation
speed is maximized and the pressure level is optimized by the
device. The monitor takes measurements while the cuff is both
inflating and deflating. This results in a faster measurement pro-
viding greater comfort to the user.

BEFORE YOU START

You must install 1 type AA (1.5 volt) battery and attach the cuff to
the monitor before using it. To install battery (or replace it if the
"Low Battery" symbol appears on display), proceed as follows:
1 .
Slide the battery cover as shown to remove from the device.
2 .
Insert batteries into designated areas
ensuring a correct match with positive (+)
and negative (-) terminals as indicated
on cuff.
3 .
Return battery cover by sliding back on to
monitoring device.
NOTE: To ensure correct operation, insert
batteries as indicated on cuff diagram .
?
E-4
All manuals and user guides at all-guides.com
LifeSource Health Line (Toll-Free): 1-888-726-9966