Tabla de contenido
Publicidad
Assembling the welding machine
The standard composition of this welding installation consists
of:
• COMPACT 240M generator.
• Ground lead integrated with the machine 3 m long.
The supply also includes the rear wheels for moving the weld-
er, a chain for securing the gas cylinder to the cylinder trolley,
a handle for moving the machine by hand and two eyebolts for
lifting the machine.
Perform the following operations before using the machine:
• Remove the welding generator and all relative accessories
and components from the packaging.
• Check that the welding apparatus is in good condition, other-
wise immediately inform the retailer or distributor.
• Check that all ventilation grilles are open and that no objects
obstruct the free passage of air.
• Assemble the machine as shown in figure A.
FIG. A
Model
Single-phase power supply 50/60 Hz
Mains supply: Z
max
Power input @ I
Max
2
Delayed fuse (I
@ 60%)
2
Power factor / cos
Maximum efficiency degree
Open circuit voltage (max)
of switch positions
Current range
Duty cycle @ 100% (40°C)
Duty cycle @ 60% (40°C)
Duty cycle @ 35% (40°C)
Duty cycle @ 20% (40°C)
Wire diameter
Standards
Insulation class
Protection class
Dimensions
Weight
(*) IMPORTANT:
• This plant meets the requirements laid down in the EN/IEC 61000-
3-12 standard on harmonic currents.
• This system, tested according to EN/IEC 61000-3-3, meets the re-
quirements of EN/IEC 61000-3-11.
9
Table 1
COMPACT
240M
V
230
(*)
kVA
11,9
A
25
0,96
0,58
V
22 ÷ 50
7
A
50 ÷ 250
A
110
A
150
A
200
250
mm
0,6 ÷ 1,2
IEC 60974-1
IEC 60974-10
IP 23 S
H
mm
860-540-790
kg
59
Publicidad
Tabla de contenido
