3.
Close the lid. Make sure that the steam release handle is pointing to
"Sealing" mark on the lid.
4.
Press the "Steam & Egg" button and press the "-" button to change the
time to 2 minutes.
5.
In 5 seconds, your multicooker will go into the preheating cycle (display
showing "00:10").
Within a few minutes steam will start coming out for a minute or two until the
Float Valve pops up and seals the cooker. Within another minute or two the
working pressure will be reached, and the countdown timer will begin. Once
the countdown is finished, your multi cooker will beep and automatically
go into the. "Keep Warm" mode. That's it. The test is complete. Press the
"Keep-Warm/Cancel" button and/or unplug the unit. Once the pot
cools down, you can open it and are ready to try your favorite recipe.
CARE AND MAINTENANCE
Regular care or maintenance is essential in ensuring that this product is safe for use.
If any of the following circumstances take place, please stop using the appliance
immediately and contact the retail store or online merchant. When:
•
Power cord and plug suffer from expansion, deformation, discoloration,
damages, etc.
•
A portion of power cord or the plug gets hotter than usual.
•
Electric multicooker heats abnormally, emitting a burnt smell.
•
When powered on, there are unusual sounds or vibrations. If there is dust or
dirt on the plug or socket, please remove dust or dirt with a dry brush.
CLEANING
CAUTION: please make sure the appliance has cooled down and is unplugged before
cleaning.
1.
Clean the product after each use. Wipe the black inner housing rim and slot
dry with cloth to prevent rusting on the exterior pot rim.
2.
Remove the lid and take out the inner pot, wash them with detergent, rinse
with clear water and then wipe dry with a soft cloth. The stainless-steel inner
pot is also dishwasher safe.
3.
Use water to clean the lid, including the sealing ring (which can be removed),
exhaust valve, anti-block shield, and wipe them clean with dry soft cloth. Do
not take apart the steam release pipe assembly.
4.
Clean the cooker body with clean damp cloth. Do not immerse the cooker
into water. Do not use a wet cloth to clean the pot while the power
cord is plugged into the power outlet. Troubleshooting If you experience
any problem with the appliance, please contact the retail store or
online merchant. For technical assistance and product return information.
The cases in the following tables do not always indicate a faulty cooker.
Please examine the cooker carefully before contacting the support for repair.
- 21 -