Klarstein PARFORCE DUO Manual De Instrucciones página 29

Problems
Burner will not light
using ignitor.
Burner will not mach
light.
Sudden drop in gas
flow or low flame.
Flames blow out.
Persistent grease fire.
Flashback...
(fire in burner tube(s)
Possible cause
Electrical issues
1. Electrode cracked
or broken;" sparks at
crack."
2. Electrode tip not in
proper position
3. Wire and/or
electrode covered with
cooking residue.
4. Wires are loose or
disconnected
5. Wires are shorting
(sparking) between
igitor and electrode.
6. push button sticks
at bottom sparking
between ignitor and
electrode.
1. See "gas issues;" on
previous page.
2. Improper method of
match-lighting.
1. Grease buildup.
2. Excessive fat in
meat.
3. Excessive cooking
temperature
High or gusting winds.
Low on LP gas.
Excess flow valve
tripped.
Grease trapped by
food buildup around
burner system.
Burner and burner
tubes are blocked.
Prevention/ Solution
1.Replace electrode.
2.Tip of electrode should be
pointing toward port hole in
burner. The distance should
be 1/8" to 3/16". Adjust if
necessary.
3.Clean wire and or electrode
with rubbing alcohol and clean
swab.
4.Reconnect wires or replace
electrode/wire assembly.
5.Replace ignitor wire
6.Replace ignitor
7.Inspect wire insulation and
proper connection. Replace wires
if insulation is broken.
1. See "Pilot Gas Control Ignition"
section of use and care.
1. Clean burners and inside of
grill/ firebox
2. Trim fat from meat before
grilling.
Turn front of grill to face wind or
increase flame height.
Refill LP tank.
Refer to "sudden drop in gas
flow" above.
Turn knobs to OFF. Turn gas off at
LP tank. Leave lid in position and
let fire burn out. After grill cools,
remove and clean all parts.
Turn knobs to OFF. clean burner
and/or burner tubes. See burner
cleaning section of use and care
manual.
EN
29