Kerf Insert; Depth Adjustment - Bosch 4310 Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:40 AM Page 17
The kerf insert should be adjusted close to the
blade, but without touching the blade, to avoid tear-
out on the bottom of the workpiece.
1. Lower the head assembly and lock into position.
2. Loosen the six (6) kerf screws using the multi
purpose tool or multi purpose "L" wrench (Figure
12).
3. Adjust the kerf inserts as close to the blade
(teeth) as possible without touching the blade.
4. Tighten the kerf screws.
NOTE: At extreme bevel angles the saw blade may
slightly cut into kerf insert.
• When the diameter of the blade has been reduced
due to sharpening, it may be necessary to adjust
the depth stop. When a new blade is installed, it
is necessary to check the clearance of the blade to
the turn table structure.
Setting Blade Depth for Normal full Cuts
• The depth stop adjustment is a feature used when
cutting grooves in the workpiece. (See page 30 for
cutting grooves.)
1. Loosen and turn both of the lower Jam Nuts to just
above the threaded end of the Depth Stop Bolt
(Fig. 13).
2. Press Depth Stop Release Button and pull up
Depth Stop Bolt until nuts hit the bottom of its sup-
port frame.
3. Set the table to the 0° miter position. Push down
and slide back saw head to the full back position.
4. While looking at both the blade and the corner
where the fence meets the table, turn the Depth
Stop Bolt to set the blade depth to about 1/4 inch
below the table's surface.
5. Release the saw head to the up position.
6. Turn both lower Jam Nuts to be tight against the
bottom of the support frame. Tighten nuts against
each other.
7. Practice slide cutting (with tool unplugged) to verify
that the blade does not touch table. If it clears the
table, make a practice cut (with tool plugged) on
Adjustments

Kerf Insert

Depth Adjustment

scrap wood to verify that the cut goes completely
through the lower front edge of the workpiece
C UTION
the blade and the turn table structure. The blade
could be ruined if it cuts into the table structure.
Setting Blade Depth for Cutting Grooves
The depth stop can be easily adjusted to limit the
cutting depth, such as when creating a rough slot.
-17-
figure 12. Kerf Insert
Do not start the miter saw without
checking for interference between
(See page 30 for instructions)
Depth Stop
Release Button
lower
Jam Nuts
figure 13. Depth Adjustment
Kerf
Screws
Kerf
Inserts
Bolt
Upper Jam
Nuts
Depth Stop

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

4410

Tabla de contenido