Kerf Insert; Bevel Stop - Bosch CM8S Instrucciones De Funcionamiento

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 18
WARNING
source before
adjustment or repair.
Kerf Insert Adjustment
The kerf inserts should be adjusted close to the
blade, but without touching the blade, to avoid tear-
out on the bottom of the workpiece.
1. Hold the saw head assembly down and push in the
head assembly lock pin (item 36 – page 9) to keep
the saw in the DOWN position.
2. Loosen the four kerf screws using a 4mm Hex key,
(figure 15).
3. Adjust the kerf inserts as close to the blade (teeth)
as possible without touching the blade.
4. Tighten the kerf screws.
NOTE: At extreme bevel angles, the saw blade may
slightly cut into kerf insert.
Checking 0° Bevel Stop Setting
1. Hold the saw head assembly down and push in
the head assembly lock pin (item 36 – page 9) to
keep the saw in the DOWN position.
2. Slide the head assembly completely to the back
and engage the slide rail lock knob by tightening
the knob to the right (clockwise) (item 25 – page 9).
3. Rotate the table to the 0° miter position.
4. Pull the bevel lock lever forward to unlock the
head assembly.
5. Tilt the
(counterclockwise), then rotate to the right
(clockwise) until you feel the stop in the vertical
position. This is where the saw is currently set for
0° bevel cut.
6. Use a combination square to check that the blade
is 90° (square) to the table. Place the square's
ruler edge against the table and slide it to contact
the blade with the vertical side of the square's
head (see figure 16).
7. Check that the saw blade's plate (not teeth) is
touching the square's 90° side. If the saw blade's
plate is not in full contact with the square's body
90° side, follow the "Calibrating Blade at 0º Bevel"
procedures.
Adjustments
To avoid possible
disconnect plug from power
performing any assembly,
0° Bevel Stop
saw assembly to the

Kerf Insert

injury,
FIG. 15
Kerf
Screws
FIG. 16
left
18.