Automatic Icemaker - Fagor FQ8925X Manual De Instrucciones

About the automatic icemaker.
A newly-installed refrigerator may take 12 to 24 hours to begin making ice.
Pull the upper freezer shelf
straight out to access the ice-
maker. Always be sure to replace
the shelf. The shelf can be used
for storage.
34
All manuals and user guides at all-guides.com

Automatic Icemaker

The icemaker will produce seven cubes per cycle–
approximately 100–130 cubes in a 24-hour period,
depending on freezer compartment temperature,
room temperature, number of door openings and
other use conditions.
To access the icemaker: Pull the shelf above the
ice drawer straight out. Always be sure to replace
the shelf.
If the refrigerator is operated before the water con-
nection is made to the icemaker, set the power
switch in the O position.
When the refrigerator has been connected to the
water supply, set the power switch to the l position.
You will hear a buzzing sound each time the ice-
maker fills with water.
The icemaker will fill with water when it cools to –
10°C. A newly-installed refrigerator may take 12 to
24 hours to begin making ice cubes.
Throw away the first few batches of ice to allow the
water line to clear.
Be sure nothing interferes with the sweep of the
feeler arm.
When the bin fills to the level of the feeler arm, the
icemaker will stop producing ice. It is normal for
several cubes to be joined together. If ice is not
used frequently, old ice cubes will become cloudy,
taste stale and shrink.
If ice cubes get stuck in the icemaker, the green
power light will blink. To correct this, set the power
switch to O and remove the cubes. Set the power
switch to I to restart the icemaker. After the ice-
maker has been turned on again, there will be a
delay of about 45 minutes before the icemaker re-
sumes operation.
NOTE: In homes with lower-than-average water
pressure, you may hear the icemaker cycle mul-
tiple times when making one batch of ice.
Ice Storage Drawer
To access ice, pull the drawer forward.
To remove:
Set the icemaker power switch to the O (off) posi-
tion. Pull the drawer straight out and then lift past
the stop position.
To replace:
When replacing the drawer, be sure to press it
firmly into place. If it does not go all the way back,
remove it and rotate the drive mechanism 1/4 turn.
Then push the drawer back again.
To access ice or reach the power switch:
1. Lift the bin, then pull it forward until the bin
stops.
2. Lower the bin to access ice or reach the power
switch.
NOTE: In order to take full advantage of the tilt-out
ice bin, only store items on the shelf below the ice
bin that are no taller than the lowest point on the
bin.