Door Alignment - Fagor FQ8925X Manual De Instrucciones

ROLLERS
The rollers have 3 purposes:
• Rollers adjust so the door closes easily when opened about
halfway. [Raise the front about 5/8" (16 mm) from the floor.]
• Rollers adjust so the refrigerator is firmly positioned on the
floor and does not wobble.
• Rollers allow you to move the refrigerator away from the wall
for cleaning.
Final leveling adjustments should be made after the refrigera-
tor has been installed.
To adjust the rollers:
1. Remove the base grille by opening the doors, removing the
screws at each end, and pulling it straight out.
2. Turn the front roller adjust-
ing screws clockwise to
raise the refrigerator, coun-
terclockwise to lower it.
Use a 3/8" hex socket or
wrench, or an adjustable
wrench.
3. These models also have
rear adjustable rollers so
you can align the refrigera-
tor with your kitchen cabinets. Use a long-handled 5/16"
socket wrench to turn the screws for the rear rollers–clock-
wise to raise the refrigerator, counterclockwise to lower it.
4. Replace the base grille.
All manuals and user guides at all-guides.com
Installation Instructions

DOOR ALIGNMENT

After leveling, make sure that the refrigerator door is 1/16"
higher than the freezer door.
To align the doors, adjust the refrigerator door.
1. Using a 7/16" socket wrench, turn the door adjusting screw
to the right to raise the door, to the left to lower it. (A nylon
plug, imbedded in the threads of the pin, prevents the pin
from turning unless a wrench is used.)
2. After one or two turns of the wrench, open and close the re-
frigerator door and check the alignment at the top of the
doors.
39