Scott SOLDIER Manual Del Usuario página 6

TYPE A & B
1
Applicable to all joint impact protectors. Type A is the
standard dimensions of protection for the average user.
Type B has an additional wider area of protection compared
to type A.
LEVEL
The performance is based on the amount of impact transmission measured in kN (kilo Newton).
The EN 1621-1 (shoulder, elbow, knee, hip, leg) standard provides 2 levels of protection: level 1 and
2
level 2. Level 1 protectors shall have an overall mean value below 35kN, each single strike shall not
exceed 35kN in the area I, and 50kN in the area II and III. Level 2 protectors shall have an overall
mean value below 20kN, each single strike shall not exceed 20kN in the area I, and 30kN in the
area II and III.
Level 2 protectors offers higher performance than Level 1 protectors.
Level 2 protectors offer the highest level specified by the CE standard. Due to the extra level of
protection Level 2 protectors may be heavier, thicker and less ergonomic than the Level 1 protectors.
It is up to the responsibility of the rider to choose the correct level of protection according to their
needs, their experience, their performance and skills.
TEMPERATURE
3
T+ means the protection is tested and certified for temperatures up to +40 degrees Celsius
T- means the protection is tested and certified for temperatures down to –20 degrees Celsius
All Scott protections are certified with ambient and wet conditioning. Wet conditioning testing is
used to simulate the high humidity experienced during sports.
• VII. HOW TO ADJUST YOUR PROTECTOR
CHOOSING YOUR CORRECT SIZE
It must be chosen in reference to the size indicated in the follow-
ing size chart or on the garment itself. SCOTT Sports SA shall not
accept any complaints arising from the use of an incorrect fit-
ted protector.
KNEE GUARDS
TOP
OPENING
BOTTOM
OPENING
ENGLISH - 6
O_16_MANUAL_Soldier_V3.indd 6
A: Category and type of protection
A
B: Level of protection
B C D
C: T+: High temperature impact test passed
D: T-: Low temperature impact test passed
Reference for Personal Protective Equipment that is in
EN 1621-1:2012 compliance with the European harmonized technical
standard used in the design and CE certification
Warning! The end user should carefully read the instruction
before using the product (PPE).
S
cm inch
39-42 15.5'-16.5'' 42-45 16.5''-17.5' 45-48
32-35 12''-14'''
Category: S: shoulder & forearm, E: elbow, K: knee, H: hip,
L: leg Type: A, B
1
2
M
cm inch cm
35-38 14''-15' 38-41
3
3
A B
A B
I II III I II III
KNEE ELBOW
L XL
inch cm
17.5'-19' 48-50 19'-19.5''
15''-16'' 41-43 16''-17''
inch
20.11.15 09: